YENRA - CONDUCTIVE FABRIC GASKET FIT RECORD
Guide: https://yenra.com/gaskets/conductive-fabric.html
Updated: September 16, 2026

Use this record for a specified enclosure revision and candidate part.
Dimensional fit is one input to qualification; complete assembly testing
against the actual product requirements remains necessary.

Project / engineer / date:
Enclosure revision / seam location / drawing:
Gasket manufacturer / exact part / lot:
Part datasheet revision and location:
Mating materials / finishes / surface preparation specification:
Attachment / adhesive / intended electrical contact path:
Fasteners / spacing / closing-force limit:
Temperature / moisture / expected opening cycles:
Frequency range / EMC target / applicable test method:

DIMENSIONS - millimeters
Free gasket height nominal h:
Free height tolerance / minimum / maximum:
Closed gap nominal g:
Closed gap minimum / maximum / measurement locations:
Nominal compression = (h - g) / h x 100 percent:
Minimum and maximum compression including height and gap tolerances:
Allowed working compression and source:
Force-deflection evidence and source:

Illustrative example, holding h fixed at 2.0 mm:
g = 1.4 mm -> (2.0 - 1.4) / 2.0 x 100 = 30 percent.
g = 1.2 to 1.6 mm -> 40 down to 20 percent.
These invented dimensions do not establish an acceptable operating range.

QUALIFICATION
Closure and deformation result:
Corner / join / between-fastener contact assessment:
Approved contact evaluation method and result:
Reopening or environmental test conditions and results:
Assembly EMC configuration / report / result:
Other seams, vents, connectors and cable entries included:
Exceptions / unresolved issues / next test:
Approved by / date:

REVISIT WHEN CHANGED
Check enclosure finish, gasket part or supplier, adhesive, profile,
fastener spacing, dimensions and environmental or electromagnetic targets.